Jason Morgan
07-30-2005, 11:20 AM
Introduction and hello in a previous thread led to some technical difficulties with the photos. I think I have it down now. Here are some pics of my shop, but I have a question.
I have a Ridgid jointer that I think I have all tuned up, however every board I run takes a large cut off the front end and a small cut off the back end. I have everything flat and coplanar to within my 0.0025 feeler gauge. Any other suggestions? It is my technique? Can it make that big of a difference?
Thanks!
http://www.sawmillcreek.org/attachment.php?attachmentid=22218&stc=1
Basement shop east end.
http://www.sawmillcreek.org/attachment.php?attachmentid=22219&stc=1
Basement shop west end (jointer in question)
http://www.sawmillcreek.org/attachment.php?attachmentid=22220&stc=1
Jointer and planer
http://www.sawmillcreek.org/attachment.php?attachmentid=22221&stc=1
PM64A with 4'x8' PW outfeed table/assembly area
http://www.sawmillcreek.org/attachment.php?attachmentid=22222&stc=1
CMS and DP on east wall
Thanks in advance for your help.
I have a Ridgid jointer that I think I have all tuned up, however every board I run takes a large cut off the front end and a small cut off the back end. I have everything flat and coplanar to within my 0.0025 feeler gauge. Any other suggestions? It is my technique? Can it make that big of a difference?
Thanks!
http://www.sawmillcreek.org/attachment.php?attachmentid=22218&stc=1
Basement shop east end.
http://www.sawmillcreek.org/attachment.php?attachmentid=22219&stc=1
Basement shop west end (jointer in question)
http://www.sawmillcreek.org/attachment.php?attachmentid=22220&stc=1
Jointer and planer
http://www.sawmillcreek.org/attachment.php?attachmentid=22221&stc=1
PM64A with 4'x8' PW outfeed table/assembly area
http://www.sawmillcreek.org/attachment.php?attachmentid=22222&stc=1
CMS and DP on east wall
Thanks in advance for your help.