Bill Hodson
02-16-2015, 7:52 PM
Hi all,
I am using a Meistergram 1612 flatbed engraver with a mercury series controller & it seems not to hold its settings very well.
Occasionally during a job it loses its vertical setting & goes further down than what it has been set to.
Any ideas?
Thanks
Bill
I am using a Meistergram 1612 flatbed engraver with a mercury series controller & it seems not to hold its settings very well.
Occasionally during a job it loses its vertical setting & goes further down than what it has been set to.
Any ideas?
Thanks
Bill