Maker of this dovetail saw?

[Jim Davis]

Howdy, I'm hoping one of you will recognize this logo stamped on the right side of the back of an offset-handle dovetail saw. I have rubbed chalk in the imprint to make it show up better, but the stamp didn't make a full impression, so it probably needs previous acquaintance to recognize it.

306850
Thanks for looking.306849

[george wilson]

Can't read it,but those type saws I have seen were all German.

[Bill Houghton]

Strictly speaking, it's less likely to be a dovetail saw than a trimming saw. If the teeth are unset on the side opposite the handle, it's for trimming off plugs, dowels, and other stuff that winds up proud of the surface.

[Jim Davis]

Yes, that makes sense. There is very little if any set and it certainly is made for trimming.

Thanks

Jim