Clark Pace
02-07-2015, 6:02 PM
Ok,
So I had a little fire. Not big, but the little flame was enough to be right over one of my bearings. Which melted a bit. So now lines are not straight or circles perfectly round. When it hits that un-even part the laser head wobbles a bit. Well I sanded the bearing down a bit. Now it's better, but still not how it was.
I have a redsail x700. Do any of you know of a place the sells bearings.
306356
So I had a little fire. Not big, but the little flame was enough to be right over one of my bearings. Which melted a bit. So now lines are not straight or circles perfectly round. When it hits that un-even part the laser head wobbles a bit. Well I sanded the bearing down a bit. Now it's better, but still not how it was.
I have a redsail x700. Do any of you know of a place the sells bearings.
306356