Peter Hartman
02-05-2015, 4:48 PM
I don't have a bench, and I wont have a bench until I have a bigger shop. My first project after getting my table saw was building this outfeed table:
https://lh3.googleusercontent.com/-L73cqcUEzWE/Utm8RWGH5DI/AAAAAAAAWcY/hpbHmR31fYQ/w1094-h820-no/IMG_20140117_172630.jpg
I would like to put a wood screw vice on this side on the left. The top is removable, and setting on dowels. The frame is mortise and tenon. Once I have the vice figured out I am going to put in 3 28" drawers on this side. Does any one have an examples of similar setups?
I borrowed a beall kit (http://www.bealltool.com/products/threading/) (1 1/8th) to make the screw and nut.
https://lh3.googleusercontent.com/-L73cqcUEzWE/Utm8RWGH5DI/AAAAAAAAWcY/hpbHmR31fYQ/w1094-h820-no/IMG_20140117_172630.jpg
I would like to put a wood screw vice on this side on the left. The top is removable, and setting on dowels. The frame is mortise and tenon. Once I have the vice figured out I am going to put in 3 28" drawers on this side. Does any one have an examples of similar setups?
I borrowed a beall kit (http://www.bealltool.com/products/threading/) (1 1/8th) to make the screw and nut.