Jim Koepke
01-31-2015, 8:19 PM
My wife saw a five drawer cabinet at an estate sale for $20 we talked the price down to $10. Since she wants to use it for storing glass for her stained glass work it needs some reinforcement. Guess who gets that job…
It is a good job for some story sticks.
305673
The one with the slide was set to the drawer depth from face to back. The scrap stick was marked to the depth from the back of the front rails to the back of the cabinet. The Odd Jobs was used to do the math to determine the thickness of the stile to support the runners that will help support the weight in the drawers. Using the front of the drawer left a little wiggle room in the equation.
305672
The piece for the stile was then marked to be ripped.
305670
After ripping and smoothing it was set inside the cabinet to mark where the drawer runners would be placed.
305669
Dados were cut out to accommodate the runners. After the dados were cut a hole was drilled in the center of the dados. The stile was then set in place and the holes were used as guides to drill through the back of the cabinet. Two screws were inserted from the inside to hole the stile in place. After the first two runners were installed, the inside screws could be removed.
The runners were made from shop scrap. Oak and what looks like maple.
305671
Holes were bored through the front rails so dowels could be inserted to support the center rails.
It isn't fine cabinetry, but if it makes the wife happy then everyone is happy.
jtk
It is a good job for some story sticks.
305673
The one with the slide was set to the drawer depth from face to back. The scrap stick was marked to the depth from the back of the front rails to the back of the cabinet. The Odd Jobs was used to do the math to determine the thickness of the stile to support the runners that will help support the weight in the drawers. Using the front of the drawer left a little wiggle room in the equation.
305672
The piece for the stile was then marked to be ripped.
305670
After ripping and smoothing it was set inside the cabinet to mark where the drawer runners would be placed.
305669
Dados were cut out to accommodate the runners. After the dados were cut a hole was drilled in the center of the dados. The stile was then set in place and the holes were used as guides to drill through the back of the cabinet. Two screws were inserted from the inside to hole the stile in place. After the first two runners were installed, the inside screws could be removed.
The runners were made from shop scrap. Oak and what looks like maple.
305671
Holes were bored through the front rails so dowels could be inserted to support the center rails.
It isn't fine cabinetry, but if it makes the wife happy then everyone is happy.
jtk