View Full Version : Positioning the laser head.
Neville Stewart
01-18-2015, 11:58 AM
I have a 6515 controller on my Weike 9060 running Lasercut. When I use the control panel to move the head it moves in increments of 1mm it seems. Is there a way to increase that amount or to move it continually when button is held down?
Bert Kemp
01-18-2015, 12:07 PM
On my rabbit I have to hit the esc a few times to clear the pad then hold the arrow key down it starts slow but then goes faster
Neville Stewart
01-18-2015, 12:10 PM
Mine only moves in incremental steps of 1mm. Pain in the bum.
Bert Kemp
01-18-2015, 12:14 PM
Doesn't sound right PM Lucy
Neville Stewart
01-18-2015, 12:17 PM
Thanks Bart. I'll do that, I rarely need it but when I do...
Bill George
01-18-2015, 1:03 PM
On my machine control panel there are settings. Jog distance comes to mind. It sets the amount of movement in mm when you are using the arrow keys.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.