Derek Arita
01-15-2015, 5:21 PM
I'll be doing a short review of the G0563 later, however right now I need help. I did the adjustment to center the oscillating belt, however I really only get about 1/4" of oscillation on the belt. Specs say I should be getting 3/4" of oscillation. I called Griz a few times for help and tried their suggestions, however they were just guessing and the end result was no change in oscillating amplitude.
I'm hoping that one of you has this machine and has figured out the adjustment to get the most oscillation on the belt. This machine has a small eccentric cam that, via adjustable arms, moves the entire motor assembly so that it changes the belts "center", thereby causing the belt to oscillate up and down. Griz techs really don't seem to know how to increase the oscillation amplitude, so I'm hoping one of you do.
I'm hoping that one of you has this machine and has figured out the adjustment to get the most oscillation on the belt. This machine has a small eccentric cam that, via adjustable arms, moves the entire motor assembly so that it changes the belts "center", thereby causing the belt to oscillate up and down. Griz techs really don't seem to know how to increase the oscillation amplitude, so I'm hoping one of you do.