View Full Version : Photo engraving granite using Corel and VLS6.60
Keith Colson
01-12-2015, 2:37 AM
I wasted half of my day playing with granite today. A customer is threatening to come in this week for some granite photo engraving. I finally got it sorted using Corel Draw and my Universal laser cutter. I ended up with 100% power and 50% speed with my 60 watts. It took 30 minutes to engrave a 300x300mm granite tile at density 3. It was the cheap kind of tile with lots of flecks in it. I am sure a super black tile would have been much easier but they are very expensive here.
Here are a couple of pictures. As usual I am keen on constructive feedback The big question I have is what is the durability of these engraved granite tiles? Will they damage, fade and wear? Do I need to protect it with a coating etc.
304056
And zoomed in to see the detail of the image processing
304057
Cheers
Keith
Bernie Fraser
01-12-2015, 7:11 AM
Keith that seems to be a lot more power for granite than I use, but I am still only learning myself. My default with a Rayjet 30 Watt is power 30 speed 50.I even found that sometimes the photo looked better if I dropped the power down to 20. I found if I used too high power detail was lost. Same if I used high dpi to engrave. 333 looked better than 600 dpi. Granite will not fade or be effected by rain so it is great for outdoors. Unsure if it needs a coating for protection. The thing that you have going for your current setting is that it is easy to distinguish the image.
Dan Hintz
01-12-2015, 9:20 AM
I ended up with 100% power and 50% speed with my 60 watts
Did you reverse those settings by mistake? That's WAY more power than you should need to use...
Keith Colson
01-12-2015, 9:01 PM
Hi Guys
Yes, you are right the power is much higher but there is a reason behind that. My image has a 10% black density with large contrast radius. This gave me a much brighter sharper image than I was able to obtain with other methods I tried.
I can engrave at less than half the power with an image density of 20% or more but I cannot get the bright white and sharp contrast using that method. The granite I have tends to make a large spot if I want it bright so I compensated for that with a large contrast radius and a low density image
I would attach the file but it is too big. If you have any Corel test files for granite I am keen to see how you have set them up.
Cheers
Keith
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.