Lasercut 5.3 missing engrave option

[Jonathan Bowen]

So with hurricane lasers now defunct I am having trouble finding all the software to run my laser. I downloaded lasercut from Just Add Sharks and tried to use old config files from previous installs. This worked fine when setting up my laptop but now I've swapped to a different workstation and followed similar process and allowed it to keep the old config file from a previous install. I've been cutting for about a day now and went to load a file that needed engraving and found that option gone! I tried swapping in a few different config files from the working laptop install but nothing is helping. Any ideas what files need to be swapped so that it will use the correct machine options?

EDIT: Found it. It was the syscfg.ini that did it.