David Delo
01-04-2015, 2:00 PM
Got a chuckle out of Dennis Ford's post so thought I'd post another oops e daisy. Had this small walnut piece on the vacuum chuck last week and was trying to get rid of a covered defect that had surface while finishing the bottom tenon. As you can see I reached a point where the ID and OD became equal and needed to hit the stop button quickly. Turned a piece of curly maple as a plug, pressed & glued it in place and finished it up. Came out okay but not good enough to give away so I guess I've got a place to put small parts. Little bit of a bummer because this piece was the first I've used walnut oil as an aid to help reduce tear-out on this dry as a popcorn fart walnut and it had helped greatly.
303369303370303371303372303373
303369303370303371303372303373