PDA

View Full Version : Table saw straight line sled



Matt Evans
01-01-2015, 8:44 AM
Haven't posted much for a long time, but figured id try to start out by posting a few of the more used jigs and fixtures I've made over the past couple years.

This one is a a straight line jig for the table saw. A few simple hold downs and a straight wide board are all you need to make one. If your saw is set up well enough you can get glue line juts straight off the saw with a well made jig like this.

Malcolm Schweizer
01-01-2015, 9:03 AM
This is on my list to make. I buy a lot of rough sawn (read: "poorly sawn") lumber.

Curt Harms
01-02-2015, 6:42 AM
Add a couple stops and it works pretty well as a tapering jig, too.