3/8 router collet for Hitachi M12vc

[Michael Weber]

I'm looking for a 3/8 router collet for my Hitachi M12vc, 2 1/4 hp router. They don't show such on their parts, just the 1/2 and 1/4. Looking around I find that the Hitachi collet looks a lot like the Bosch collet for their 1613, 1617, 1618 and 1619 series which is available in 3/8. Anyone know if the Bosch will fit the Hitachi? Need to mount a long end mill of that diameter for a few deep mortises. Open to other solutions.
Mike

[pat warner]

Use a 3/8 x 1/2 sleeve. Would never expect the other guys taper or thread to enjoy the nest of an alien router.

[Mike Heidrick]

Does precise bits sell a collet setup for it?

[Matt Day]

Lee Valley is where I got my sleeve, in case you need a source.

[Rick Fisher]

Lee Valley is where I got my sleeve, in case you need a source.

What Matt said ....

[Michael Weber]

Thanks for the sources. Precise does sell them but has a minimum order. Looks like it's a sleeve from LV, though I am concerned about run-out at the length I want. I could kick myself for selling my Delta mortiser I thought i'd never use again. :mad: Bah Humbug