Dewalt Track saw ?

[Robyn Horton]

Can someone with a Dewalt track saw and has the 102" and 59" tacks measure the rib the saw slides on with a vernier caliper for me , either in mm or standard ? Have a problem with one of the tracks ribs but I'm not sure which one is causing the problem so I can get it exchanged . The saw has to be adjusted for each track so the saw slides correctly

[Cary Falk]

Approximately 0.664"

[Kevin McCluney]

Same here - 0.664"

[Graeme Lunt]

Metric is standard....

[Robyn Horton]

Thanks for the measurements ... both of my rails are off by those measurements my long rail is 0.660 and the 59" is .6650 , I'll try and get both changed

[Cary Falk]

0.005" shouldn't make that big of a difference. It's extruded Al, not machined. It may just be the difference between everybody's calipers.

[ed vitanovec]

The .005 is more than likely within the manufacturing tolerance of the extrusion, but it would not hurt to give Dewalt a call. I would think the adjustment for that rib has some kind of spring pressure to compensate for this.