steven c newman
12-01-2014, 3:39 PM
Just $5 for this 16-1/2" long plane. 301301
Fellow has a 2-1/8" wide, tapered iron, with a chipbreaker that is just angled, no rounded "hump". Bolt to hold them is HUGE. Photos are after a good clean up, and about 6 coats of BLO. Thing was VERY dried out.
Has a BIG mouth.
301303
The Carrol Channing of Jack planes? I ground the edge of the iron to a decent camber, maybe about a 9" or so. Seemed to do ok on a test track of barn wood fir. Handle is offset a bit to the right
301305
and has a nail to hold it in place....
Sole is worn at an angle, like the owner had run this plane at the angle for years. I did get some of it planed away, but, seems to be the way this plane works best. Kind of smallish, compared to the 22" Try plane from Ohio Tool Co. 301306 ah, yep. No other markings on this plane, other than the "W. Butcher" on the iron and chipbreaker. Might be worth the $5:D
Fellow has a 2-1/8" wide, tapered iron, with a chipbreaker that is just angled, no rounded "hump". Bolt to hold them is HUGE. Photos are after a good clean up, and about 6 coats of BLO. Thing was VERY dried out.
Has a BIG mouth.
301303
The Carrol Channing of Jack planes? I ground the edge of the iron to a decent camber, maybe about a 9" or so. Seemed to do ok on a test track of barn wood fir. Handle is offset a bit to the right
301305
and has a nail to hold it in place....
Sole is worn at an angle, like the owner had run this plane at the angle for years. I did get some of it planed away, but, seems to be the way this plane works best. Kind of smallish, compared to the 22" Try plane from Ohio Tool Co. 301306 ah, yep. No other markings on this plane, other than the "W. Butcher" on the iron and chipbreaker. Might be worth the $5:D