Mike Rother
11-29-2014, 9:08 PM
Hi all-
attempting my first deep dive into a PM 60 resto. About to tackle changing the cutterhead bearings. Manual says one bearing is an:
MRC 205SZZ
the other is a
Hoover 99 R 12
searched online and can find the MRC 205SZZ but no luck with the Hoover. I've searched on the forum here and have seen people refer to new R 12s, I just dont know where or what to ask for. I'm a total novice when it comes to this. Any help on pointing me in the right direction as to where to get and what to ask for would be great.
also-
if anyone has done this before, should I be changing anything else while I have it apart? Housing etc?
thanks a million for any help
attempting my first deep dive into a PM 60 resto. About to tackle changing the cutterhead bearings. Manual says one bearing is an:
MRC 205SZZ
the other is a
Hoover 99 R 12
searched online and can find the MRC 205SZZ but no luck with the Hoover. I've searched on the forum here and have seen people refer to new R 12s, I just dont know where or what to ask for. I'm a total novice when it comes to this. Any help on pointing me in the right direction as to where to get and what to ask for would be great.
also-
if anyone has done this before, should I be changing anything else while I have it apart? Housing etc?
thanks a million for any help