Mike vonBuelow
11-10-2014, 7:12 PM
Ok, so I got some 1/16" wood to play around with, and I came up with this 18" x 10" laser cut eagle project - might say it's a puzzle (?)
300044
But when I tried to glue the outer pieces, they curled up on me, despite having a flat weight on top. Does anyone have any tips to prevent this?
Note* The middle/eagle pieces went on without a hitch, but I did cut & glue them down during the warmer afternoon. The outer pieces were cut this morning, when it was cool. Would this be a factor?
Thanks in advance
300044
But when I tried to glue the outer pieces, they curled up on me, despite having a flat weight on top. Does anyone have any tips to prevent this?
Note* The middle/eagle pieces went on without a hitch, but I did cut & glue them down during the warmer afternoon. The outer pieces were cut this morning, when it was cool. Would this be a factor?
Thanks in advance