Jack Jackson
11-06-2014, 11:06 PM
So I've got an opportunity to buy a Grizzly 0640x bandsaw in the near future for a good price. I just wondered if anyone here had experience with this particular saw and had any general advice for me... anything to check before buying (it's set up but hasn't been used)... any disadvantages to this model... I noticed it has an inverter motor that is 3 phase but runs on 220v 1 phase power - anything I should know about that? I've already powered it up (didn't cut anything) and it sounded good and had very little vibration.
I will use it almost exclusively for woodworking - resawing and general bandsaw cuts. Basically I can probably get this for the same price as a much smaller machine so it's almost a no-brainer but I just wanted to see what you guys had to say about it...
Thanks
Jack
I will use it almost exclusively for woodworking - resawing and general bandsaw cuts. Basically I can probably get this for the same price as a much smaller machine so it's almost a no-brainer but I just wanted to see what you guys had to say about it...
Thanks
Jack