PDA

View Full Version : Bottom Up Raster in Laserwork



Ian Johnson
10-10-2014, 11:05 AM
Does anyone know if it is possible to raster from the bottom up in RDCam/LaserWork? There is a bottom-up option, but it seem to apply to vectoring. If you have several closed areas/individual objects to cut out it will run each of them from the bottom up, but I can't seem to find any way to make it raster in that direction. Does anyone know if it has this capability and I can't find it, or am I out of luck?

AL Ursich
10-10-2014, 11:13 AM
I had a thought that a easy way to solve this for me was to install another smoke / dust collection pipe in the front of my very old Epilog Laser with the ability to work from either end. A side benifit for me, working in a area of the table and rails that see little use. As in placing the work in the front of the table after establishing a ruler system. Need to replace a mirror first.. too many toys....

Nicolas Silva
10-10-2014, 2:27 PM
It might be in the print driver. The ULS driver has it as an option.