Albert Lee
10-06-2014, 5:27 PM
Bought myself a 10 years old SCM 5 RCS1100 sander over the weekend, it sands between 43-44 inches.
it chews 38amp at full load(400v here), I only have 60amp supply, and I need to run the compressor (7.5kw) and the extractor (4kw) at the same time.
I am hoping my power supply should be ok.
cost? $5500 USD, freight is another $500 USD
my current sander is a 30 years old SCM UNO 930mm wide (37inches). I have spent some money on it to keep it in good condition, if the 5RCS is too big I might onsale it...
some pics below
297967
297968
297969
297970
it chews 38amp at full load(400v here), I only have 60amp supply, and I need to run the compressor (7.5kw) and the extractor (4kw) at the same time.
I am hoping my power supply should be ok.
cost? $5500 USD, freight is another $500 USD
my current sander is a 30 years old SCM UNO 930mm wide (37inches). I have spent some money on it to keep it in good condition, if the 5RCS is too big I might onsale it...
some pics below
297967
297968
297969
297970