Enrique Bava
09-17-2014, 11:54 PM
296901296902Hello List: This is a follow-up to my previous thread regarding table slides.
I am posting some pics to show how it is now and my alternative reworking. The mega-slides I was referring to would be a ball-bearing row (male part mockup shown) sliding on t-slots on each side. I would use the ball bearings every 12 inches or so, to distribute the load all along the beam length. This would replace the drawer slides.
(sorry, I am not having luck uploading the pics)
I am posting some pics to show how it is now and my alternative reworking. The mega-slides I was referring to would be a ball-bearing row (male part mockup shown) sliding on t-slots on each side. I would use the ball bearings every 12 inches or so, to distribute the load all along the beam length. This would replace the drawer slides.
(sorry, I am not having luck uploading the pics)