If you own a Rockler Dovetail Jig

[Johnnyy Johnson]

I have one on order and have never used a DT jig. I have seen pics of side views of drawer box without the front. The tail in some is about an 1/8 from the front. In some the tail is in the center with less depth of cut. WillI beb albe to adj this cut or is it fixed at 9/16? I am beally looking forward to start new project with this jig.

[Jim Rimmer]

I assume your talking about half blind DT. You should be able to adjust the depth of cut by adjusting your routher bit depth.