Phil Tomlinson
09-06-2014, 3:41 PM
Tried to see if someone had already asked/answered this question but I did not find it. Apologies if this has been done before.
Trying to help a buddy reassemble an old Grizzly G1023 Cabinet Saw. Pretty sure it has a new-ish motor and switch but everything has been sitting in boxes for about ten years, so...
The motor has four wires coming out of it. Black, Red White & Green. Obviously the green is the ground.
The replacement switch has three wires coming out of it (going back to the old motor), just black, red and green. It runs on to a 3-wire plug.
There's no model number on the motor, weirdly, but it's a 3HP, 1Phase, 3450RPM, 18A motor that says Grizzly KH on it--possibly meant for another machine because I had to adapt it to the table saw bracket.
The switch is a Taian HNFB-16KK that looks like it belongs on a Grizzly Table saw.
Any help is appreciated!
Trying to help a buddy reassemble an old Grizzly G1023 Cabinet Saw. Pretty sure it has a new-ish motor and switch but everything has been sitting in boxes for about ten years, so...
The motor has four wires coming out of it. Black, Red White & Green. Obviously the green is the ground.
The replacement switch has three wires coming out of it (going back to the old motor), just black, red and green. It runs on to a 3-wire plug.
There's no model number on the motor, weirdly, but it's a 3HP, 1Phase, 3450RPM, 18A motor that says Grizzly KH on it--possibly meant for another machine because I had to adapt it to the table saw bracket.
The switch is a Taian HNFB-16KK that looks like it belongs on a Grizzly Table saw.
Any help is appreciated!