daniel coyle
09-01-2014, 9:15 PM
Earlier in the summer I started a thread about my machine because it
shut down in the middle of a job by tripping the circuit in my shop
seemingly broke the Power Supply in the process of this
I sent the PS (and the transfer board) back to China for repair and later diagnosed the problem as a faulty power strip (or, at least, I think) that I had been using to connect all of the 120V accessories (pump, water chiller, exhaust etc.) and the 120-240 1500W step up convertor that the 240v laser runs off. I did this so that I would foolproof myself from running the laser without the water chiller going. Now that I have the PS and transfer board back and installed I have hooked the machine directly up to my 240V outlet. The machine turns on, the fan on the PS supply is going, but the display on the control panel is blank and the control panel is not working. The machine does not move back to the origin/zero on the table. See in the video
https://www.youtube.com/watch?v=Ut-g8bVajps&feature=youtu.be
Any ideas on what might be going on here? Might I have damaged some other piece that is now preventing normal operation?
Dan
shut down in the middle of a job by tripping the circuit in my shop
seemingly broke the Power Supply in the process of this
I sent the PS (and the transfer board) back to China for repair and later diagnosed the problem as a faulty power strip (or, at least, I think) that I had been using to connect all of the 120V accessories (pump, water chiller, exhaust etc.) and the 120-240 1500W step up convertor that the 240v laser runs off. I did this so that I would foolproof myself from running the laser without the water chiller going. Now that I have the PS and transfer board back and installed I have hooked the machine directly up to my 240V outlet. The machine turns on, the fan on the PS supply is going, but the display on the control panel is blank and the control panel is not working. The machine does not move back to the origin/zero on the table. See in the video
https://www.youtube.com/watch?v=Ut-g8bVajps&feature=youtu.be
Any ideas on what might be going on here? Might I have damaged some other piece that is now preventing normal operation?
Dan