Daner Steel
08-23-2014, 10:58 AM
He all,
I picked up a used planer General#30-300-HC With the 2 sided carbide knifes.
I looked like to me that the previos owner ran some boards through full of nails:eek:
Almost all knifes were nicked and chipped.
Anyway I ordered 60 new blades and they only sent me 30(there mistake) 30 more on the way.
There were some of the blades chipped on both sides so I replaced them, but some I was able to flip over to the unused side and managed to get the whole cutter head with sharp blades.
Its now planeing the stock down good and fast but I'm getting about 5 groves that are cutting a bit deeper.
Any Idea what this could be?
Any help would be most appreciated
Thanks
Dan
I picked up a used planer General#30-300-HC With the 2 sided carbide knifes.
I looked like to me that the previos owner ran some boards through full of nails:eek:
Almost all knifes were nicked and chipped.
Anyway I ordered 60 new blades and they only sent me 30(there mistake) 30 more on the way.
There were some of the blades chipped on both sides so I replaced them, but some I was able to flip over to the unused side and managed to get the whole cutter head with sharp blades.
Its now planeing the stock down good and fast but I'm getting about 5 groves that are cutting a bit deeper.
Any Idea what this could be?
Any help would be most appreciated
Thanks
Dan