Epilog Job Manager

[Chris J Anderson]

Does anybody have any thoughts on using the Epilog Job Manager compared to using the standard print driver ?

Cheers,
Chris

[Ed Maloney]

If it had a job time estimator I would go for it, but it doesn't. I don't like to muck around with upgrades unless there is some true value. Some folks on the Epilog Fans FB page have mentioned they have run into problems with the new driver.

[David Rust]

same as Ed... wish it had a job estimator!

[Chris J Anderson]

Thanks for the info, I'm a bit the same, I am hesitant to upgrade unless there is some real benefit.

(As far as job estimating, for measuring area and vector lengths, you can use ecut).

I like the Trotec Job Control, for the fact that the job is stored there until you delete it, you don't need to start coreldraw / print etc.

Cheers,
Chris

[Dee Gallo]

I'm of the "If it ain't broke..." school. Unless I have to upgrade, I don't make changes.