Todd Burch
08-20-2014, 8:25 PM
Just got home with a old Delta/Rockwell heavy duty Shaper, an old bullet motor Unisaw and 2 powermatic planers (16" and a 20"). Paid $833 out the door for all 4.
Unfortunately, the 16" planer appears to have "rolled" somehow - probably off the forks of a forklift driver that wasn't paying attention. During the roll, it bent the motor support (fixable), the belt guard (fixable) and bust the bolted on knife sharpener all to pieces (not fixable). Shame - 'cuz just that attachment alone is about $400 if you can find it.
The unisaw will sell fast I suppose. Last one I listed for $300 sold within a few hours.
The Powermatic 20" (model 220-B, 5HP, 3 phase) I will keep. It has a good knife sharpener attached. I will keep the shaper too. I think it has a 1/2" spindle, but I will have to look closer when I have the time.
Storage unit is now busting at the seams, so I suppose my sickness with have to subside for a while.
Todd
Unfortunately, the 16" planer appears to have "rolled" somehow - probably off the forks of a forklift driver that wasn't paying attention. During the roll, it bent the motor support (fixable), the belt guard (fixable) and bust the bolted on knife sharpener all to pieces (not fixable). Shame - 'cuz just that attachment alone is about $400 if you can find it.
The unisaw will sell fast I suppose. Last one I listed for $300 sold within a few hours.
The Powermatic 20" (model 220-B, 5HP, 3 phase) I will keep. It has a good knife sharpener attached. I will keep the shaper too. I think it has a 1/2" spindle, but I will have to look closer when I have the time.
Storage unit is now busting at the seams, so I suppose my sickness with have to subside for a while.
Todd