A home for two full sized saws

[steven c newman]

That used to just hang from a nail in a ceiling joist. Building a tool chest, so
295024
I made some room in the lid. A bit of scrollsaw work to make some wooden keepers
295025
Then attached this lid to the chest
295026
I HATE doing hinges by myself, not enough hands. Stand the chest up, and prop the lid open
295027

The top saw is a Pheonix Warranted "Ship saw", the bottom saw is a Disston D-8 crosscut from about 1953. Might just work out.

[steven c newman]

Now, I am trying to figure out what will go where on the inside. May have to dial up Roy & Chris to see how a few trays will be done.

So far, all the lumber came from salvaged stuff. Like an old broken down bed frame, a waterbed platform. and some old barn siding. Store bought a pair of hinges, and a bottle of Elmer's. Price so far seems to be about right for me.

Sizes of this box: Lid 33-5/8" long, by 17-3/8" wide. Box stands ( with lid) at 23-3/8" tall. Box itself is 31-1/2" long, by 16-1/8" deep.

Have a few brace and bits to store away, a few "extra" planes, and a few assorted hand tools. Will be adding casters later on. Maybe next paycheck. Oh, and a chain for that lid.

[Pat Barry]

Now, I am trying to figure out what will go where on the inside. May have to dial up Roy & Chris to see how a few trays will be done.

So far, all the lumber came from salvaged stuff. Like an old broken down bed frame, a waterbed platform. and some old barn siding. Store bought a pair of hinges, and a bottle of Elmer's. Price so far seems to be about right for me.

Sizes of this box: Lid 33-5/8" long, by 17-3/8" wide. Box stands ( with lid) at 23-3/8" tall. Box itself is 31-1/2" long, by 16-1/8" deep.

Have a few brace and bits to store away, a few "extra" planes, and a few assorted hand tools. Will be adding casters later on. Maybe next paycheck. Oh, and a chain for that lid.
You might want to put some casters on it so it can be easily moved around in your shop. Maybe could find some salvage ones during one of your hunting trips? I like the saw storage.

[george wilson]

You might want to consider putting some supportive clips in the middle of those saw blades. It would help keep them from developing a permanent curve from being stored in a horizontal position while gravity works at them.

[steven c newman]

I will see what I can cobble up. Maybe just a single screw to hold a clip-like "J", maybe?

First floor residents have arrived in the chest295089


And so drill bits ,too295090
and a space for a few braces
295091
I have installed a rail for the next tray to ride on. Added a piece to the back of the chest
295092
That matches the trim around the lid. Glued and screwed into place. Seems to keep the lid from going on over, don't need to prop it up. Not sure about adding a chain keeper.

Went out and priced some thin stock for tray sides....YIKES! I'll see what I can come up with.....

[Jim Matthews]

Looking good.

Chain is traditional, upholstery twine will work as well.

[george wilson]

Too bad they don't make wooden orange crates now. Can you scrounge up a wooden wine crate? Probably not. Grocery stores use them for displays,and everyone wants to buy them more than they want to buy the wine!! Plane the brands off.

Yes,a rotating wooden clip will do.