What bit to buy?

[CHRIS gibbson]

294635294636

We recently removed some cabinets to make room for larger appliances. I would like to make some dummy panels to fill in the space. I've searched a woodcraft and a couple other sites but can't find the bit that matches this edge profile. It's a pretty standard door so not sure what I'm missing.

Thanks for the help.

[Jamie Buxton]

The curved part of the profile is an ogee bit. The flat part is a bevel cut on the table saw after you've made the ogee pass.

Eagle has several ogees which could be very close. http://www.eagleamerica.com/product/v169-1802/ea_-_ogee You might not have to get 100.00% match. A sixteenth one way or the other is not likely to be obvious.

[Tom Ewell]

Probably get more use with an ogee bit down the road but there is a bit for your door edge that is similar.

http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_door.html#door_lip_bits_anchor

[CHRIS gibbson]

Probably get more use with an ogee bit down the road but there is a bit for your door edge that is similar.

http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_door.html#door_lip_bits_anchor


Thanks for the help. Decided to go with the ogee. Looks like a close match.

Chris