Ohio Tool Co. #81: Updated

[steven c newman]

A while back, picked a Try plane. 293720 wasn't all that bad a shape. Cleaned to old finish off, planed the sole flat. Sharpened the iron up. Gave it an oil finish while the iron was being worked on293721Both eyes had started to seperate, so a bit of glue and a clamp to hold them in place. Got the iron all sharpened up, and tried it out293722on some old pine293723wasn't too bad, but a bit tough to handle. While researching the plane, found a company that does refurbs for sale. They had an #81, and it had a tall front knob. Ok, drag out the old Craftsman lathe, again. Turned a couple knobs out of Spalted Maple. It was about the right size, and it had just been laying around, gathering dust. Of the two knobs, one wasn't too bad, the other? Not that good. Drilled a hole through the center. Dug up a steel, #6 slotted screw. Installed the knob. Applied an oil finish to try and match existing.293724Hmm, not too hateful293725Not sure if the grain direction is "correct", can always rotate the knob a wee bit293726Before the finish had been applied, I tried the "new" plane out on some white oak, very easy to use, easy to push along. Shavings almost flew up out of the opening, full width of the board I was jointing. Might just be a "Keeper"?:D

[steven c newman]

and photos of them shavings293738had it set a bit deep, re-set it a bit shallower293739These shavings seemed to just fly straight up out of there, then wrap around anything in their way, like a knob..a wrist....

Very comfy to use, stable on narrow edges. Thanks to a more consistant grip out front... the knob. A little less pressure on the tote, too. Even at the thicker setting, plane was still very easy to push along. Shavings were almost full width of the edge being planed. Once the edge had been jointed, had a full width the entire length of the board. Me Likey!

[Moses Yoder]

Not sure why we can't just have a "Like" button. I like you plane. Nice work.

[David Weaver]

Not sure why we can't just have a "Like" button. I like you plane. Nice work.

This was brought up here years ago, and we decided that we "don't like the like button" idea.

[Terry Beadle]

Sure looks like a keeper to me. Woodies are really good jack planes. I have 4 of them. 2 are transitionals, one a German jack and the other is a Steve Knight super duper. I sure do miss Steve Knight's work and planes. I hope he's doing well in the cad operations.

Enjoy the shavings !

[Chris Griggs]

Real nice job on that restoration Steve.

As far as like buttons...I agree with Dave...I dislike like buttons...

[steven c newman]

One could always "rate" this thread, I suppose...LOL

Anyway, do I use this as a Jointer? Or as a try plane for panel work? 22" long. The Jointer that is in the shop is a 24" long Stanley #31. 2" longer, with an iron that is just an 1/8" wider. Also have a DE6c iron body plane, at 18" long.

Nice stable of long planes?

There IS a Stanley T19, #5-1/2 lurking around, as well. It tends to trail along with the Stanley T17, #5.....:D

[David Weaver]

It's a try plane and should be set up as such, but it will edge joint most of the stuff you're likely to use in cabinet sized pieces. It should be able to follow your rough plane and leave an almost finished surface.