Lee Tincher
07-25-2014, 12:33 PM
Please help.
I have a Chinese laser and I changed out the flashback in the power supply. I've had to do this before when I notice that the laser engraving is starting to fall off. When I did it this time I made the mistake and did not notice that the power cable came off the end of the tube before testing it. When I tested it it made a pop notice and as soon as that happened I hit the EOS and checked it. I reattached the cable and used silicone to attach it.
When I tested it again the laser is work fine but the X Y axis is not moving. The step motors have power to them cause I can not manually move the arm when the power is on. But when I try to send a file to the laser the laser fired but there is no movement.
I replaced the RDLC320 board and control panel thinking that maybe I shorted it out. But with the new one installed it still does the same thing, no X Y axis movement. I am unable to move the x y axis with the directional controls as well.
Please any help to know why my axis movement is not working would be greatly appreciated
Thank you
I have a Chinese laser and I changed out the flashback in the power supply. I've had to do this before when I notice that the laser engraving is starting to fall off. When I did it this time I made the mistake and did not notice that the power cable came off the end of the tube before testing it. When I tested it it made a pop notice and as soon as that happened I hit the EOS and checked it. I reattached the cable and used silicone to attach it.
When I tested it again the laser is work fine but the X Y axis is not moving. The step motors have power to them cause I can not manually move the arm when the power is on. But when I try to send a file to the laser the laser fired but there is no movement.
I replaced the RDLC320 board and control panel thinking that maybe I shorted it out. But with the new one installed it still does the same thing, no X Y axis movement. I am unable to move the x y axis with the directional controls as well.
Please any help to know why my axis movement is not working would be greatly appreciated
Thank you