View Full Version : a couple of 20" tenon saws

Ron Bontz
07-21-2014, 1:18 PM
I assume I should post these here. It's been a while Just some of my latest gildings. I have had the handles laying around on my bench for a few months. Finally decided to get them out of my hair. So I threw them in the mix with a few other saws. First is a sycamore 20" x 5" canted, x 032" . No frills no thrills straight 3/4" spine.
293460 The second is Madrone Burl with white mother of pearl and ornate spine.
293461293462They were both made 10ppi rip. ( Not filed yet ) Best wishes.

Mike Wilkins
07-21-2014, 3:46 PM
Fine work. These look to pretty to use. Almost makes you want to give up the fossil-fueled tools and take up hand work exclusively. Almost. I am what you would consider a hybrid woodwooker, using both to complete a project.

Mike Allen1010
07-22-2014, 11:38 PM
Ron, Absolutely beautiful in design, materials and execution - and I know first hand innfunctionality too! Thanks for positng.


John T Barker
07-27-2014, 11:24 PM
Damn beautiful! You re good.