steven c newman
07-02-2014, 10:00 PM
Part of that $10 deal for the Bucking saw to prune a tree with, was a handsaw for it's bolts.292294well, had to trash out that little saw's tote to get what turned out to be RIVETS out of it. Plate looked like.....well, can't say that on here. Trash can.
Well....maybe not:confused: seems i found a spare tote laying around in the shop, marked as a "Pattern". Hmmm, weelll IF I can clean up the plate, and marry it to the Pattern Tote..
Not expecting a whole lot, got some 60 grit sandpaper and the palm sander out. Gave each side of the plate a good going over. Pattern tote was a close match....292295 Hmm, maybe we can save it? Shined up nicely292296 turned out to be an 8ppi crosscut. Not a kink, not a dent, very little pitting, no missing teeth. Only thing now is to find a few saw bolts, and a WS medallion. Maybe give the teeth the once over, as well.
Well, off to Feebay to find a few bolts...
Well....maybe not:confused: seems i found a spare tote laying around in the shop, marked as a "Pattern". Hmmm, weelll IF I can clean up the plate, and marry it to the Pattern Tote..
Not expecting a whole lot, got some 60 grit sandpaper and the palm sander out. Gave each side of the plate a good going over. Pattern tote was a close match....292295 Hmm, maybe we can save it? Shined up nicely292296 turned out to be an 8ppi crosscut. Not a kink, not a dent, very little pitting, no missing teeth. Only thing now is to find a few saw bolts, and a WS medallion. Maybe give the teeth the once over, as well.
Well, off to Feebay to find a few bolts...