View Full Version : Hollowing tools-shop made arm brace
Dennis Ford
06-17-2014, 9:44 PM
I have been using a Sorby Arm Brace with home-made tools for quite a while. It works fine but is best with the lathe at a higher height than is comfortable for normal turning. Today I made this brace in an attempt at a more ergonomic tool.
Sorby Arm brace on right, home made brace on left
Don Nicholas
06-18-2014, 12:22 AM
Fine looking piece of work both in fit and finish. How does it work for you?
robert baccus
06-18-2014, 9:28 PM
Looks good--does it help.
Thomas Canfield
06-18-2014, 10:48 PM
Let us know how it works. I know the Don Pencil like yours is somewhat awkward.
Dennis Ford
06-19-2014, 9:31 AM
I used it yesterday and it works fine, really about the same as the Sorby; but it puts my elbow about 4 inches higher when the tool is level. I have had good results with the Sorby and by raising the lathe, it is comfortable to use. This one is comfortable with the lathe at a more normal height.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.