View Full Version : Anyone with a Sawstop PCS with 52" extension?
Ryan Barry
06-09-2014, 10:41 PM
Can you tell me what the measurements are for how far the extension support legs are set back from the front/back/right edge of the table top?
just dying to finish my DIY mobile base before my saw arrives.
Thank you!
Matt Kestenbaum
06-09-2014, 11:12 PM
From the front edge of the fence support tube to the leg is ~4.75"
From the right edge of the out feed table to the Legs is ~7"
From the back most edge of the rear bracket to the leg is !2.75"
Of course my 52" 3HP PCS, and its extension table, is close to 4 years old now (bought about 6 months after they started making this saw), so it may vary from the latest model.
Enjoy the new tool!
Matt
Ryan Barry
06-09-2014, 11:21 PM
Thank you kindly fine sir!
I am going to give it some extra space so if its off a few inches it should be ok.
From the front edge of the fence support tube to the leg is ~4.75"
From the right edge of the out feed table to the Legs is ~7"
From the back most edge of the rear bracket to the leg is !2.75"
Of course my 52" 3HP PCS, and its extension table, is close to 4 years old now (bought about 6 months after they started making this saw), so it may vary from the latest model.
Enjoy the new tool!
Matt
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.