Robert Tepper
05-13-2014, 12:37 AM
Good Evening to all,
I hope everyone is having a prosperous year.
I have two questions for 400 users. The product that I manufacture is 6 x 6 " square I am currently running a Rayjet 300 and I am able to manufacture 8 each of a 6 x 6" at once. I need larger capacity. The 400 will allow me to manufacture 24 at one time.
On the 400, does the machine mark the entire 24" area?
I will need a vector aluminum table. Does the vector table on this machine allow me to tuck the edge of a .0075 mylar sheet into the corner and side of the frame?
I am able to do this on the Rayjet and then I weight the mylar sheets down with wood strips.
Trotec advertises that the working area is 24 x 39". The 39" width works well since all I will need is 36". Anyone have any problems with this model before I send my right arm and make a deal with the bank!
Thank you in advance for any replies.
Robert
I hope everyone is having a prosperous year.
I have two questions for 400 users. The product that I manufacture is 6 x 6 " square I am currently running a Rayjet 300 and I am able to manufacture 8 each of a 6 x 6" at once. I need larger capacity. The 400 will allow me to manufacture 24 at one time.
On the 400, does the machine mark the entire 24" area?
I will need a vector aluminum table. Does the vector table on this machine allow me to tuck the edge of a .0075 mylar sheet into the corner and side of the frame?
I am able to do this on the Rayjet and then I weight the mylar sheets down with wood strips.
Trotec advertises that the working area is 24 x 39". The 39" width works well since all I will need is 36". Anyone have any problems with this model before I send my right arm and make a deal with the bank!
Thank you in advance for any replies.
Robert