PDA

View Full Version : Left hand side flames up more



Keith Upton
05-12-2014, 1:08 PM
When I vector cut objects out that are close to the left edge of my substrate, that they tend to flare up more. Paper masking on acrylic is bad and so is Baltic birch. Across the rest of the cutting bed I would say that flame ups are normal and only happen sporadically. But down that left hand side, they flame up every time. As far as I can tell, everything is level. Any thoughts on what it might be or what I should check? It's an Epilog Mini 24 60w that is only several months old (with really low usage hours).

Dan Hintz
05-12-2014, 2:28 PM
Airflow is likely uneven across the table... it's probably stagnant in that area.

John Bion
05-12-2014, 2:37 PM
Following on Dan’s thoughts: is there a chance your air pipe is pinching/getting kinked when it moves to the left?