View Full Version : Help wisth DowelMax Information
Keith Krueger
04-26-2014, 7:38 AM
I am intending to write a SketchUp Plugin that would layout the holes for a dowel joint made with a DowelMax fixture. I need some basic dimensions to get started with concept.
1. End of block to first hole centerline
2. Edge of block to centerline of the 5 holes2
3. Distance between the holes
Thanks
Keith
Tom Esh
04-26-2014, 10:32 AM
Inch:
0.666 Bore Spacing (~43/64)
0.4175 Bore-to-Edge distance (~27/64)
3.5 Overall Length
Bill Huber
04-26-2014, 12:36 PM
I am intending to write a SketchUp Plugin that would layout the holes for a dowel joint made with a DowelMax fixture. I need some basic dimensions to get started with concept.
1. End of block to first hole centerline
2. Edge of block to centerline of the 5 holes2
3. Distance between the holes
Thanks
Keith
You could also add the Jessem Paralign.
To the center-line of the first hole is 3/8".
The holes are spaced 3/4" apart.
Edge of block to first hole is 3/8", then 3/4" to center of the next, then 3/4" to center of the next and so on.
| 3/8" O - 3/4" O - 3/4" O - 3/4" O - 3/4" O - 3/8" |
Block is 3 3/4" wide.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.