Marc Nicoloudis
04-25-2014, 11:43 AM
Hello everyone!
I started the laser up today(Accuris 30watt w/ synrad tube), and am getting a very weak fire of the laser on full power, 4 speed, which would normally cut through 1/16" material just fine. Checked the power supply and it is putting out 30v as it should. Has a green light indicating operation is normal. Removed it just in case to blow any dust out of it. Over the last couple of months, the laser would sometimes not fire when rastering, but after a couple of heavier power vector cuts, it would engrave(raster) as usual. Any ideas? Is what folks speak of as the "RF" supply the same as a power supply? Any help would be appreciated. Thanks, Marc
I started the laser up today(Accuris 30watt w/ synrad tube), and am getting a very weak fire of the laser on full power, 4 speed, which would normally cut through 1/16" material just fine. Checked the power supply and it is putting out 30v as it should. Has a green light indicating operation is normal. Removed it just in case to blow any dust out of it. Over the last couple of months, the laser would sometimes not fire when rastering, but after a couple of heavier power vector cuts, it would engrave(raster) as usual. Any ideas? Is what folks speak of as the "RF" supply the same as a power supply? Any help would be appreciated. Thanks, Marc