Wade Lippman
04-11-2014, 9:53 AM
Used the spindle sanding capacity today for the first time; to even out a bandsaw cut.
While it hogged off a lot of material quickly, I had a few problems.
1) The dust collection was terrible. I suppose having the hose 30" away makes it difficult, but I wonder if anyone has suggestions for improving it.
2) The little table is crooked! When I tried to staighten it out, it threw the belt tracking off. It appears that the tracking makes the belt crooked, which effectively makes the table crooked. Am I doing something wrong? Is there a way to straighten the table out?
While it hogged off a lot of material quickly, I had a few problems.
1) The dust collection was terrible. I suppose having the hose 30" away makes it difficult, but I wonder if anyone has suggestions for improving it.
2) The little table is crooked! When I tried to staighten it out, it threw the belt tracking off. It appears that the tracking makes the belt crooked, which effectively makes the table crooked. Am I doing something wrong? Is there a way to straighten the table out?