Peter Widders
03-16-2014, 3:10 AM
Hi to all 'Creekers,
First time post here after a while as a 'lurker': particularly in the Workbench area as that is my current project.
I have a Zinken Compact 21 combination machine and have managed to break the belt for the power feed on the thicknesser. I have a new belt on order and am endeavouring to remove the pulleys etc from the drive shaft so that I can get the new belt onto the shaft of the motor. I have a brief manual that is no help with how to get this section apart. Any advice from anyone who has a manual (pdf to - pwidders@yahoo.com.au - I'm an optimist!) or assistance to get the bits apart and replaced would be much appreciated.
Cheers
Peter Widders
First time post here after a while as a 'lurker': particularly in the Workbench area as that is my current project.
I have a Zinken Compact 21 combination machine and have managed to break the belt for the power feed on the thicknesser. I have a new belt on order and am endeavouring to remove the pulleys etc from the drive shaft so that I can get the new belt onto the shaft of the motor. I have a brief manual that is no help with how to get this section apart. Any advice from anyone who has a manual (pdf to - pwidders@yahoo.com.au - I'm an optimist!) or assistance to get the bits apart and replaced would be much appreciated.
Cheers
Peter Widders