View Full Version : Wood Gear Clock
Jerry Honkanen
03-12-2014, 6:54 PM
The Excapment took me three tries to get a good one. The final one will keep good time but I have three teeth that could use a bit of fine tuning.
http://youtu.be/XGvWJR3L9cw
Thanks for looking
Jerry
Steve Peterson
08-04-2014, 4:02 PM
Hi Jerry,
I know it has been a while since you posted this. I should browse the CNC forum more often.
How is the clock coming along? It looks like a nice escapement. Are the segments holding up without cracking?
The outer diameter will need to change size with humidity changes. I have often wondered if a there is a perfect spoke shape that would allow expansion in length at the same rate as the change in diameter. Straight spokes are obviously bad.
Steve
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.