John Calhoun
03-01-2014, 8:24 PM
I have a 60 Watt G460 Shenhui. I spent the past two days uncrating it and setting it up.
Everything appears to be set up correctly. Water is running (I got the CW5000 just in case I upgrade to a higher wattage in the future), ground is grounded, air pump operating, HV wires twisted around the electrodes on the laser tube.
I power on the top switch, the second switch, the third switch. The machine goes through a start-up mode where the laser head moves to the back-right and then comes to roughly the center. The CW5000 after the initial beep/alarm appears normal.
I have a piece of the white tape covering first mirror — hit the "Pulse" button on the LCD and no hole. The ammeter never twitches — just sits at zero.
Any trouble shooting tips? Could my power supply be DOA?
I searched the forums and came up empty.
Everything appears to be set up correctly. Water is running (I got the CW5000 just in case I upgrade to a higher wattage in the future), ground is grounded, air pump operating, HV wires twisted around the electrodes on the laser tube.
I power on the top switch, the second switch, the third switch. The machine goes through a start-up mode where the laser head moves to the back-right and then comes to roughly the center. The CW5000 after the initial beep/alarm appears normal.
I have a piece of the white tape covering first mirror — hit the "Pulse" button on the LCD and no hole. The ammeter never twitches — just sits at zero.
Any trouble shooting tips? Could my power supply be DOA?
I searched the forums and came up empty.