Michael Mahan
02-23-2014, 7:27 PM
Allen is at again ,
http://www.youtube.com/watch?v=Jbvu6bq1Etc
the header statement by Allen of VerySuperCoolTools
This is the introduction to a motor change out on my Hitachi CB75F from the original equipment motor to a 3hp 3 phase high torque, high efficiency motor using a variable frequency drive to deliver the 3 phase power in my single phase shop. This series will cover all aspects of steel fabrication for the new motor bracket, speed and pulley calculations, machine tune up and maintenance, and blade sharpening.
http://www.youtube.com/watch?v=Jbvu6bq1Etc
the header statement by Allen of VerySuperCoolTools
This is the introduction to a motor change out on my Hitachi CB75F from the original equipment motor to a 3hp 3 phase high torque, high efficiency motor using a variable frequency drive to deliver the 3 phase power in my single phase shop. This series will cover all aspects of steel fabrication for the new motor bracket, speed and pulley calculations, machine tune up and maintenance, and blade sharpening.