Jim Koepke
02-06-2014, 8:50 PM
But I ain't going to drive in it.
Was hoping the weather forecast was correct in not having anything other than a few flurries until later Friday.
But as is often the case, the pattern shifted and it looks like there is no way I am driving to Portland tomorrow. They will just have to have the tool event without me. It looks like a lot of things are going to be closed tomorrow so folks in Portland if there is any way to get around, it might be a good chance to get some very up close an personal attention for any woodworking questions.
It is so cold the snow doesn't have any moisture. You can't even make a decent snow ball.
The big problem is a lot of places have ice under the snow. Temps outside are now about 20ºF.
Looks like a few days in hunker mode.
Did a little in the shop today. Started out at ~26ºF, finished up at ~32ºF with the heater on for a few hours.
It feels warmer when standing in front of the heater.
jtk
Was hoping the weather forecast was correct in not having anything other than a few flurries until later Friday.
But as is often the case, the pattern shifted and it looks like there is no way I am driving to Portland tomorrow. They will just have to have the tool event without me. It looks like a lot of things are going to be closed tomorrow so folks in Portland if there is any way to get around, it might be a good chance to get some very up close an personal attention for any woodworking questions.
It is so cold the snow doesn't have any moisture. You can't even make a decent snow ball.
The big problem is a lot of places have ice under the snow. Temps outside are now about 20ºF.
Looks like a few days in hunker mode.
Did a little in the shop today. Started out at ~26ºF, finished up at ~32ºF with the heater on for a few hours.
It feels warmer when standing in front of the heater.
jtk