View Full Version : Table level

Travis Wizniuk
02-05-2014, 11:11 AM
Does anyone have any experience with leveling a table on a Gwieke laser. I noticed that my laser is not cutting all the way through some stock at one corner of the table. When I look, I can clearly see that its out about 2 - 2.5mm. I looked at the jack screws and couldn't figure out how to decouple them so I can just raise one corner of the table. Any help would be appreciated.

Khalid Nazim
02-06-2014, 1:34 PM
If you have a motor under the table to move the table then you can loosen the belt pulley and then you are able to move any corner of the table.