Karl Nisbet
01-25-2014, 7:42 PM
Hello everyone, I am new to the forum but am hoping someone of you wise woodworkers will be able to help me. I have a Williams and Hussey Model 206 molder, 2hp, single phase 240 volt. My problem is this; I removed the power cord in order to replace it and also unfastened the cord from the motor to the switch. Now, I can't remember which wires go where! I believe that the power cord goes to Line 1 and Line 3, and the motor cord to T2 and T3. Does anyone have a clue about this or, even better, a picture they could post of the inside of the switch box with everything connected? I have called W+H but will need to call again if I can't find the info elsewhere.
It was really stupid o me not to snap a photo before I started to take things apart! Anyhow, hope someone out there can offer some help, I would be really thankfull!
Thanks to all
Karl
It was really stupid o me not to snap a photo before I started to take things apart! Anyhow, hope someone out there can offer some help, I would be really thankfull!
Thanks to all
Karl