View Full Version : Corel x6
TAMI WILSON
12-12-2013, 3:27 PM
just upgraded to corel X6. this is probably a simple problem but it has me scratching my head. when I send a RGB 255 red hairline outline to be cut to the laser it won't cut it. it shows up blue. like there is a RGB CMYK issue. not sure how to fix it though.
Surely someone else had this problem and has figured it out. Can't be just me?? :-)
Thanks
Tami
Mike Chance in Iowa
12-12-2013, 3:42 PM
There are many posts on this topic. A search on Corel X6 Upgrade will reveal lots of answers. This was the latest post a week or so ago.
http://www.sawmillcreek.org/showthread.php?210832-Corel-16-vs-14-and-13-engraving-quality (http://www.sawmillcreek.org/showthread.php?210832-Corel-16-vs-14-and-13-engraving-quality)
Darryl Hazen
12-13-2013, 1:37 PM
A hairline should cut regardless of color unless you have color mapping setup wrong.
Mark Sipes
12-13-2013, 2:41 PM
Trotec allows 15 different color assignments with diffrent setting... engrave, cut, none. red is just one.
Mike Null
12-13-2013, 2:43 PM
On the Trotec I believe you must use the rgb palette. X6 is set to default to cmyk so you must change the color settings and I believe this link will take you through the steps. http://www.engrave.ca/archives/5318
TAMI WILSON
12-13-2013, 3:32 PM
Thanks so much everyone. problem solved
tami
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.