any 2030 makita owners

[allan kuntz]

You may have read my earlier post about a spiral cutter head for this unit if you have read it you know the jointer side did not work out. When I took the spiral head out to put the old head back in the jointer I noticed that the belt was almost off the pulley toward the jointer side. If anyone does own one of these units could I get you to look and see if there is a gap between the pulley and the coupler. The drive pulley and the coupler on the planer side. Stupid me never took note before ripping it apart
Thank you
Al

[Brad Patch]

On my 2030 there is no gap between the driven pulley and the coupler.

[allan kuntz]

Thanks for looking Brad. now to try and figure out why the belt won't track
Al