allan kuntz
12-02-2013, 5:30 PM
You may have read my earlier post about a spiral cutter head for this unit if you have read it you know the jointer side did not work out. When I took the spiral head out to put the old head back in the jointer I noticed that the belt was almost off the pulley toward the jointer side. If anyone does own one of these units could I get you to look and see if there is a gap between the pulley and the coupler. The drive pulley and the coupler on the planer side. Stupid me never took note before ripping it apart
Thank you
Al
Thank you
Al